Installation is simple, the kit plugs in under the hood
No wire cutting or splicing
Kit comes with an illuminated rocker switch for control and to indicate when the front axle is being overridden
Designed to allow the operator to manually disable the front wheel drive mechanism by holding the hubs in the free (2WD) mode with the transfer case in 4WD low range
By allowing the front wheels to be disengaged, maximum torque is available to the rear wheels
This will also allow for sharp "All The Way Over" turns without the front axle u-joint hopping or binding
With this kit installed, the front wheels will NOT be driven through the transfer case
Allows to have full power and torque while in a high gear reduction applied to the rear axle(s) only
Write the First Review!